Non-Standard Holes and Slots

website slot hole dimension standard There are keys which are long with thread hole designed for pulling the key out of the slot On the basis of shaft diameter, the standard determines dimensions slot hewan A:You can design plated slot to be at least , non-plated slot to be at least Plated slots usually have copper pads in copper layer, the non-plated

slot hole dimension standard In figure the allowance is , meaning that the tightest fit occurs when the slot is machined to its smallest allowable size of and the mating part is  The token for the slot width is Bolt Diameter and the slot length L is Length So the label should say Ø%Diameter x %Length Slot or  • SPIROL specifies a maximum chamfer diameter of to smaller than the nominal hole diameter, whereas some industry standards only state

Share

Share

Link

Turn off sharing Copy link

See all details