How to dimension a slot in a drawing?

how to dimension a slot   Dan how slot machine works

The slot dimension is 14 mm × 14 mm The overall dimension of the pentaband antenna is 10 cm × 10 cm The L-band antenna was

However if the slot is horizontal or vertical use the TechDraw_Dimension_Horizontal_Extent or vertical equivalent If the slot is angled then, Under the Annotate Tab, pick Centerline Bisector Pick both nodes at the quadrants of the slot as shown below This will create a center line

how to book driving license test slot My crappy work around for dimensioning slots without centerlines is to dimension to the midpoint of the line and the center of the radii For Wildfire 4 and lower , select Axis Point from the top Sketch menu In Wildfire 5 or later , you add a Geometry Point